E-mail: spares01@outboardcn.com
Contact Us
TEL:86-571-86927550
E-mail:spares01@outboardcn.com
Add.:No.126, ChangDa Road, Yuhang economic and Technological Development Zone, Yuhang, Hangzhou
Home > News > Content
Method Of Replacing Outboard Machine Gear Oil
Dec 23, 2017

Method of replacing outboard machine gear oil

The outboard machine, whether it is 2 stroke Boat Engine or 4 stroke Boat Engine, either large or small horsepower horsepower, replacing gear oil are similar, there are 2 screws and remove the oil, and then put the filling process of 4 stroke Outboards oil replacement method for less than 30 horsepower 4 stroke Outboards, replace the outboard machine lubricating oil (engine oil) the process is basically the same, the 1. is first put the outboard machine at the bottom of the screw to open, will send out the old oil, completely put dry may take 30-60 minutes at the same time, remember to put the filling hole 4 stroke engine oil inside the engine cover open, can increase the permeability of oil will faster. 2., if there is no oil flowing out of the waiting oil hole, screw the screws up, then pour the oil from the Yellow machine hood oil box, pay attention not to overfill it, and see that the scale line on the yellow lid can arrive. 3. in the operation of the machine after a period of time, probably a few hours, check the oil tank oil capacity, with good oil may just because there will be air, so running after a period of time, basically the air will be excluded, should be reduced, so increasing the oil is normal. The whole process of replacement is completed.



TEL:86-571-86927550
E-mail:spares01@outboardcn.com
Add.:No.126, ChangDa Road, Yuhang economic and Technological Development Zone, Yuhang, Hangzhou

Copyright © Hangzhou Hidea Power Machinery Co.Ltd All Rights Reserved.